D.C. Worm Screw Gearmotors

AUTOMEC worm screw gearmotors type VSF25 and VSF35 are designed for all those applications requiring the output shaft at 90° respect the input shaft, where it is important the high resistance to fatigue, the compact size and the noiseless operation. All the gearmotors of this serie are manufactured with aluminum bronze worms and steel screws; output shafts are supported on ball bearings with seal rings in order to avoid the leak of lubricant.
All the gear unit of this serie are supplied lifetime lubricated by means of special long life grease, and don’t require any further lubrication or servicing.

Series VSF25 Gearmotors

VSF25 Series

If you're looking for compactness

The most compact of this serie, centre distance from worm and screw of only 25 mm.
Best compromise between compact size and high reliability.
45 to 90 watts – 12 to 170 volts d.c. permanent magnet motor.
Worm screw gearunit made with a aluminium bronze worm and steel screw, directly coupled on the motor shaft.
Sealed ball bearings.
Long life expectation, no servicing needed.

VSF35 D.C. Worm Screw Gearmotors Automec Milan

Series VSF35 Gearmotors

VSF35 Series

If you are looking for versatility

Centre distance from worm and screw of 35 mm.
Higher versatility into reduction ratio with a higher torque.
Compact size
High reliability
Power range from 45 to 90 watts – 12 to 170 volts d.c. permanent magnet motor.
Worm screw gear unit made with a aluminium bronze worm and steel screw.
Sealed ball bearings.
Long life expectation, no servicing needed.